Download Print this page

IBC P-749B Instructional Note

Controller replacement kit for dc / hc series (all models)

Advertisement

Quick Links

NOTE
Installing and servicing boiler
equipment, parts and
accessories, can be
hazardous due to gas and
electrical components.
Only trained personnel
should install or service
heating equipment.
When working on boiler
equipment, observe
precautions in the literature,
on tags, and on labels
attached to the unit.
For your safety, turn off electrical power supply at service panel and allow unit to cool before proceeding. Failure to do
so can cause severe personal injury or death. The ability to properly perform service on this equipment requires
certain expertise, mechanical skills, tools, and equipment. If you do not possess these, do not attempt to perform any
service on this equipment. A failure to follow this warning could result in possible damage to this equipment, serious
personal injury, or death.
Figure 1: P-749B DC / HC Controller
Replacement Kit
1- Replacement Controller, 500-115A
1- Instructions, IBC part 120-297
120-297B
Better
P-749B Controller Replacement Kit
Boilers
DC / HC Series (All Models)
These instructions are to be closely followed, and referenced to the
details in the boiler's current certified Installation and Operating
Instruction Manual.
PART
P-749B
Table 1: Boiler / Water heater models using this kit
Note: the previous version of this kit, P-749, predated models DC/HC 15-95 and DC/HC
15-96. Only the P-749B (software version 2.10) can replace a board for a 15-95 or 15-96.
NOTE
DESCRIPTION
Controller Replacement Kit
WARNING
When to Install the P-749B Controller Replacement
Kit
The P-749B DC / HC series boiler / water heaters Controller
replacement kit supports all models of the DC / HC series.
The controller must be configured to operate with the
boiler model.
If the old controller shows signs of corrosion or water
damage, care must be taken to identify and correct the
water source before proceeding with this replacement. If
combustion air condensation has caused water damage to
the boiler / water heater, contact your IBC representative
about part number 250-868, Deflector Shield, before
installing a replacement control board.
Tools Needed
Philips screwdriver
Small flathead screwdriver
Needlenose Pliers
www.ibcboiler.com
INSTRUCTIONAL
NOTE
BOILER MODEL
DC Series – All Models
HC Series – All Models
Page 1 of 4

Advertisement

loading

Summary of Contents for IBC P-749B

  • Page 1 Note: the previous version of this kit, P-749, predated models DC/HC 15-95 and DC/HC on tags, and on labels 15-96. Only the P-749B (software version 2.10) can replace a board for a 15-95 or 15-96. attached to the unit. WARNING For your safety, turn off electrical power supply at service panel and allow unit to cool before proceeding.
  • Page 2 Reset button to save all changes. If further information is required see the IBC publication DC / HC Controller Manual. Note: after installation, upon powering up the boiler, the board will briefly display r 2.10 and a PA x-.
  • Page 3 Better P-749 Controller Replacement Kit INSTRUCTIONAL Boilers NOTE DC / HC Series (All Models) INSTALLER’S RECORD Figure 3: User and Installer Setup Menus 120-297B www.ibcboiler.com Page 3 of 4...
  • Page 4 IBC Technologies Inc. 8015 North Fraser Way Burnaby, BC Canada V5J 5M8 Toll Free: 1.844.432.8422 Tel: 604.877.0277 Fax: 604.877.0295 www.ibcboiler.com 120-297-A-R2 89007702 April 2018 © IBC Technologies Inc. 2018 120-297B www.ibcboiler.com Page 4 of 4...