Page 1
Townsend Freestanding Townsend Freestanding Townsend Freestanding Operation & Installation Instructions Please keep these instructions for future reference. Rev A GPN: 236791...
Page 2
• We are proud of the presentation of our products. If at any time you need to freshen up the paint, your local Jindara dealer has touch-up paint available for purchase. The heater is painted in Stove Bright Metallic Black - Paint code 6309.
Page 3
Flue Requirements As per the dimensions in Table A (referencing figures 1 and 2), the Jindara Townsend must be installed with either of the • Ensure that you have a reasonable ash bed in the base of your firebox. The ash bed acts as a heat store, and helps following flue types: to maintain hot coals once the fire has burnt low.
Page 4
Townsend Freestanding Townsend Freestanding Installation Maintaining & Servicing your Jindara Wood Heater (continued) Fitting a New Door Seal Table A: Minimum clearances to combustibles, flue and hearth requirements. • Open the door and lift it free of its hinges. Note: All measurements shown below are in millimeters.
Page 5
Maintaining the Door Seal To maintain efficient and safe use of your Jindara wood heater, you may need to adjust the door handle tightness. It is important that you periodically check the door seal, to ensure that it is sealing against the face of the firebox at all points when the door is in the closed position.
Page 6
(2). The cast iron door of your Jindara Townsend should always be closed during operation, except for when you are lighting With the rear of the baffle plate pressed against the bottom back corner of the firebox, lift the baffle plate tilting or re-fueling your fire.
Page 7
Fitting the Firebricks and Firebrick Retainer DO NOT ATTEMPT TO OPERATE THIS APPLIANCE WITHOUT READING AND Your Jindara Townsend requires firebricks to be installed, to ensure that the fire operates correctly, and to prevent dam- UNDERSTANDING THESE OPERATING INSTRUCTIONS THOROUGHLY. FAIL- WARNING age to the firebox through excessive heat.
Page 8
Increase as necessary Final Inspection Prior to Use until nothing Before lighting the first fire in your Jindara Townsend, check the following list of items to ensure that your heater will within 6000mm of perform correctly, and safely: 3000mm More than 3000mm •...
Need help?
Do you have a question about the Townsend and is the answer not in the manual?
Questions and answers