Related Manuals for Eureka Jasper
Summary of Contents for Eureka Jasper
- Page 1 Jasper Freestanding Jasper Freestanding Jasper Freestanding Operation & Installation Instructions Please keep these instructions for future reference. Rev A GPN: 236788...
- Page 2 • We are proud of the presentation of our products. If at any time you need to freshen up the paint, your local Eureka dealer has touch-up paint available for purchase. The heater is painted in Stove Bright Metallic Black - Paint code 6309.
- Page 3 Flue Requirements As per the dimensions in Table A (referencing figures 1 and 2), the Eureka Jasper must be installed with either of the • Ensure that you have a reasonable ash bed in the base of your firebox. The ash bed acts as a heat store, and helps following flue types: to maintain hot coals once the fire has burnt low.
- Page 4 Jasper Freestanding Jasper Freestanding Installation Maintaining & Servicing your Eureka Wood Heater (continued) Fitting a New Door Seal Table A: Minimum clearances to combustibles, flue and hearth requirements. • Open the door and lift it free of its hinges. Note: All measurements shown below are in millimeters.
- Page 5 Firstly and carefully remove the firebox baffles and set them aside, following the instructions given on pages 4 & 5. Close the heater door. Obtain a 150mm flue brush from you local Eureka dealer. Proceed to a position where you can access the Figure 3 flue cowl, and remove it from the flue.
- Page 6 (2). The cast iron door of your Eureka Jasper should always be closed during operation, except for when you are lighting or With the rear of the baffle plate pressed against the bottom back corner of the firebox, lift the baffle plate tilting re-fueling your fire.
- Page 7 Fitting the Firebricks and Firebrick Retainer DO NOT ATTEMPT TO OPERATE THIS APPLIANCE WITHOUT READING AND Your Eureka Jasper requires firebricks to be installed, to ensure that the fire operates correctly, and to prevent damage to UNDERSTANDING THESE OPERATING INSTRUCTIONS THOROUGHLY. FAIL- WARNING the firebox through excessive heat.
- Page 8 Increase as necessary Final Inspection Prior to Use until nothing Before lighting the first fire in your Eureka Jasper, check the following list of items to ensure that your heater will perform within 6000mm of correctly, and safely: 3000mm More than 3000mm •...
Need help?
Do you have a question about the Jasper and is the answer not in the manual?
Questions and answers