Adding New Hardware To Windows Me Systems; Adding New Hardware To Windows 2000 Systems; Installing The New Wave/Pc; Software - Bose Wave PC system USB adapter Installation Manual

Installation Procedure

Adding new hardware to Windows ME systems

After you connect the USB adapter to your computer's USB port, the
"Add New Hardware Wizard" opens to tell you that a new USB audio
device was found (Figure 5).
Figure 5
Windows ME
screen when new
hardware is found
Select "Automatic search for a better driver," and click Next to continue.
When the next window tells you that Windows has finished installing the
driver, click Finish.

Adding new hardware to Windows 2000 systems

After you connect the USB adapter to your computer's USB port, the
new device drivers are installed automatically. Four different displays will
briefly flash on the screen during this process.

Installing the new Wave/PC

Note: You must connect the USB adapter cable before installing the
new Wave/PC™ interactive system software.
Insert the Wave/PC™ software CD into your computer's CD-ROM drive.
If the install program does not start automatically, go to the Start menu
and select Run. In the Run window, open d:\Setup.exe, where d is the
letter of your computer's CD-ROM drive.
If you need more help with this installation, refer to the "System Setup"
section of your Wave/PC™ system owner's guide.
8
TM

software