CreamWare Noah Step Sequencer Manual page 3

Controls
SEQ 1 - 4: Multiple instances of the Step
Sequencer exist. Each instance is
assigned to one of the Instrument slots.
Use the switches - the number of which
depends upon the operating mode ( Single,
Multi ) and the hardware version (Noah,
Noah EX) - to select the desired instance
for display and editing.
Activate SEQ1-4: Turn this switch on to
activate the step sequencer for the
corresponding slot. This is equivalent to
selecting the step sequencer as trigger
source in the MIDI Manager.
Step Sequencer
Activate SEQ1-4
Step Length: Selects the overall
resolution for the Step Sequencer (that
is, the smallest required note length). For
example, choose 1/16 if your shortest
step is a 16th note.
Possible values: 8/1, 4/1, 2/1,1/1, ½ dot,
½, ½ tr pl, ¼ dot, ¼, ¼ trpl,
1/8 dot, 1/8, 1/8 trpl, 1/16 dot, 1/16,
1/16 trpl, 1/32, 1/32 trpl, 1 Clock .
Values of the form x/1 are longer than a
beat. 4/1, then, indicates 4 beats per step.
Values with a „trpl" are triplets. 1/4trpl
indicates a resolution of four triplets, or six
steps per bar. (in 4/4). Values with a „dot"
indicate a dotted note value. Therefore, 1/
4dot stands for a dotted quarter-note (= 3
eighth notes).
Set the actual length of the individual steps
under Length per Step, where you can
enter a whole number multiple of the value
configured here for each step.
Step Loop: Switches loop playback on
or off.
Length: Select here the number of steps
to include in the loop (continuous loop).
Contents Index
3