Assembly - PRO-PULSE ME1013L Operator's Manual

ASSEMBLY

1. Curved handle
2. Handle Knobs
3. Lower bar
4. Grass box
5. Wheels
6. Lawnmower housing
Assembly
Disconnect the plug before any work on the equipment. There is a risk of injury.
Assembling the Curved Handle
1. Insert the lower bar (3) into the slot on the lawnmower housing (6).
2. Fix the bar (3) using the enclosed screws (12).
3. Fix the curved handle (1) using the enclosed screws (13) and the Handle
4. Clip the cable holder (8) into the bar (3) and thus fix the cable.
When both wing nuts are loosened, the curved handle can be folded
down for storing the equipment. Ensure that the power cable is not caught.
WARNING:
!
There is a risk of injury.
Assembling the Grass Box
1. Connect both pieces of the collection box (15).
2. Connect the handle (14) in one of the two pieces of the collection box (15).
Operation
Hanging / Removing the Grass Box
1. To install the grass box (4). lift the discharge guard (7) and hang the grass box.
Fold the discharge guard (7) onto the grass box (4). It holds the grass box in the
correct position.
2. To remove the grass box (4), lift the discharge guard (7) and detach the grass
box. Fold the discharge guard (7) back onto the mower housing (6).
Adjusting the Cutting Height
Switch off the equipment, disconnect the plug and wait for the blade to stop. There
is a risk of injury.
To adjust the lawn mower's cutting height change the position of the wheel axles as follows:
Position
1
2
3
Knobs (2) on the lower bar (3). There are two possible positions.
Do not work with the lawnmower without the collision guard or lawn box.
7. Discharge guard
8. Cable holder
9. Power cable outlet
10. Release button
11. Start lever
Cutting depth
1.18"
1.77"
2.36"
31