Specifications - Alarm.Com ADC-SEM300 Installation Manual

1. Verify the Vista panel version meets the minimum revision number required for this feature.
◦ Vista-10P rev 2.0+
◦ Vista-15P rev 3.1+
◦ Vista-20P rev 5.2+
◦ Vista-21iP rev 3.1+
2. Resync the installer code if a zone scan is not initiating upon power-up.
a. To resync the installer code, use the keypad to change the installer code to a new, unique code.
b. After resyncing the installer code, power cycle the panel and verify a zone scan is initiated.
3. Enter programming and execute *96 to reset the account number and initialize the downloader. Then exit
programming via *99, power cycle the system and verify the zone scan is initiated.
4. Verify the programming settings set during initialization are correct.
◦ Verify the Sub ID Primary *43 value is a four-digit value with no zeros (1111 or FFFF is recommended). The
SEM does not support zero values (e.g., 0000 or 1010) in
this section.
◦ Verify the Report Format Primary/Secondary *48 value is set to 7,7.
5. Power cycle the system and request the firmware version.
Questions?
If you are experiencing difficulties with your installation, please contact
866-834-0470 and we'll be happy to assist further.

Specifications

Power requirements
Cellular network
Panel interfaces
Alarm.com module indicators
SEM circuit board indicators
Operating temperature
Storage temperature
Humidity
Enclosure dimensions
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Panels/SEM_Honeywell_ADEMCO_Vista/SEM-Ho...
Alarm.com CORE Technical Support
13.6 V nominal, 125 mA nominal (continuous), 230 mA
maximum
4G LTE with 3G HSPA, 2G GSM fallback
Two keypad BUS connections, 12 V power and ground
Five LEDs (red, yellow, or green)
Five LEDs (red, green, yellow, or blue)
14 to 131°F (-10 to 55°C)
-30 to 140°F (-34 to 60°C)
90% relative humidity non-condensing
(L x W x D) 7.66 x 4.35 x 1.65 in. (19.46 x 11.05 x 4.19
cm)
at
Updated: Thu, 27 May 2021 18:46:08 GMT
20