Troubleshooting - Bose Wave radio Owner's Manual

Using your pedestal with components connected
Figure 7
AUX 1, AUX 2, and AUX 3
buttons on the pedestal for
®
the Wave radio /CD
(shown)

Troubleshooting

Problem
No sound or
sound is muffled
A connected source is
playing, but no LED is lit
With auxiliary sound sources connected to your pedestal, you can easily command Wave
radio sound from them.
Before you begin to enjoy the sound, however, take note of which component is connected to
INPUT 1, 2, or 3 on the back of the pedestal. Those numbers coincide with the AUX buttons
on the pedestal front panel, which you will press to select the component you want to hear
(Figure 7).
To select and play a specific component
1. Turn on your component using its remote or console Power button.
2. Turn on the Wave ® radio/CD (or Wave
CD remote control AUX button will do both).
3. Press the AUX 1, 2, or 3 button on the front of the pedestal.
Note that the green LED (below the AUX button you press) lights up.
To adjust the sound
®
Use the Wave radio/CD (or Wave
component that is playing.
Use the component remote control or console buttons to adjust any other feature of that
sound source and to turn the component off, as well as on.
What to do
• Make sure that both the pedestal and the radio are plugged into a functioning
power outlet.
• Check the connection of the component to the pedestal. Make sure it is connected to one
of the three pairs of INPUT jacks on the back of the pedestal.
• Make sure the pedestal RCA connectors are inserted into the AUX IN jacks, red-to-red
and white-to-white, on the Wave
Wave ® radio to its pedestal" on page 5.
• Make sure that both the pedestal and the radio are plugged into a functioning
power outlet.
®
X 1
A U
® radio) and select AUX (pressing the Wave
®
radio) remote to increase or decrease the volume of the
® /CD radio/CD (or Wave
Getting The Sound
X 3
A U
X 2
A U
LEDs
® radio). Refer to "Connect your
®
® radio/
9