Care And Maintenance Instructions - CPI STEMSHINE PRO - GP5 Operating Manual

PLEASE NOTE: GLASSES MUST BE WASHED, RINSED AND STILL WET WHEN PUT ONTO THE STEMSHINE GP5-PRO BRUSHES
Remove the glasses, clean and wet, from the glass washer. Place the glasses, one by one, on the warm, dry brushes for drying and
polishing and then remove them, ready for immediate use.
DAILY OPERATION:
Ensure the glass drier is placed in a location where the operator will find it comfortable to operate.
Insert the plug into the nearest socket.
Press the "Power" button located on the front of the dryer to start up the machine.
i) The button will illuminate indicating there is power to the unit.
ii) The brushes will begin to rotate
iii) The element heats up
iv) The fan will begin to circulate increasingly warm air around the brushes.
IT IS NOT NECESSARY TO APPLY PRESSURE WHEN HOLDING THE STEMWARE AGAINST THE BRUSHES
PLEASE NOTE: the glass drier does not clean stemware, or remove any stains on the glasses.
At the end of the day or once all stemware has been dried and polished, allow the brushes to dry out by running the machine for an additional
15 minutes prior to turning off the machine.
DAILY CLEANING
The glass polisher needs to be cleaned on a daily basis.
1. Turn the machine off and unplug it.
2. Remove the brushes as follows:
3. Place the brushes evenly on the flat rack or dish rack of your dishwasher (either laying down or standing up). Ensure they do not
overlap one another.
4. Run them through a regular wash cycle in your high temperature dishwasher - TWICE.
5. After the second regular wash cycle is complete, rinse the brushes with plenty of fresh water to remove soap and chemical that is
applied during the wash cycle.
6. Allow the brushes to drip dry overnight on the rack.
7. In the morning, place the brushes back onto the spindles. Turn the brush in a clockwise direction to lock in place. Be sure that the
brushes are correctly inserted onto the spindles.
8. After all brushes are placed on the spindles / support, plug in the machine and turn the power on. Run for approx. 15-20 minutes
or until dry.
WARNING: Do not place the glass drier in a container with water because it contains electrical parts that could be damaged and
Remove the brushes from the warm water and allow them to drip dry overnight before replacing the brushes onto the STEMSHINE
GP5-PRO glass polisher. To replace the brushes, ensure the connecting slot (A) – shown on page 8, is inserted on the top of support (B).
If the brush is not properly fixed on the support, it will not rotate once the machine is switched back on. To verify this, once the brush has
been replaced try to rotate it clockwise and then pull it gently upwards: if the brush does not come off it has been placed correctly.
Then turn t he STEMSHINE PRO™ -GP5 back on and run for approx. 15-20 minutes t o complete the drying of the brushes.
OPERATING INSTRUCTIONS
FOR EXCEPTIONAL RESULTS!

CARE and MAINTENANCE INSTRUCTIONS

To remove the brush from the support,
rotate the brush in a counter clockwise
direction while gently pulling it up-
wards. Remove the brush completely
by slipping it off its support.
cause electric shock to the operator once it is switched back on.