Logitech TRUEFORCE G923 Setup Manual page 11

2
Press the button you want to set as the dual clutch button
The only valid buttons for this are the L3 and R3 buttons
The RPM LEDs will flash red to show that you're in clutch
position setting mode
3 While in your chosen simulation or game with the car
still on a track, fully depress the clutch and gas pedals
Engage first gear and keep pressing the minus button
down until the car begins to move in-game You can adjust
the precise bite point of the clutch by using the plus and
minus buttons until you are happy with the setting
4
At this point you may test the dual clutch without leaving the
setting mode It is recommended you attempt a race start,
stop the car and adjust the bite point and then try again until
you are satisfied with the performance of the dual clutch
5
Press the Select button in the middle of the dial on the wheel
to exit dual clutch setting mode The RPM LEDs will flash
in a sequence from green to blue to show that the setting
is saved The RPM LEDs will then go out and begin responding
again to RPM output from supported games
11 ENGLISH