Functional Description; Depth Adjustment - Makita FS2500 Instruction Manual

FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.

Depth adjustment

A
B
1
► 1. Locking ring
The depth can be adjusted by turning the lock ring. Turn
it in "B" direction for less depth and in "A" direction for
more depth. One full turn of the lock ring equals 1.5 mm
(1/16") change in depth.
Adjust the lock ring so that the distance between the
tip of the locator and the screw head is approximately 1
mm (3/64") as shown in the figures. Drive a trial screw
into your material or a piece of duplicate material. If the
depth is still not suitable for the screw, continue adjust-
ing until you obtain the proper depth setting.
1mm (3/64")
1
► 1. Locator
Switch action
► 1. Switch trigger 2. Lock button
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
NOTE:
• Even with the switch on and motor running, the
bit will not rotate until you fit the point of the bit
in the screw head and apply forward pressure to
engage the clutch.
Lighting up the lamps
► 1. Lamp
CAUTION:
• Do not look in the light or see the source of light directly.
To turn on the lamp, pull the trigger. Release the trigger to turn it off.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
4 ENGLISH
1
2
1