Table of Contents
Advertisement
CONNECTING THE CABLES:
The Horizon 36V BATTERY has 3 cable connections. These will be used to connect the
VARIABLE SPEED THROTTLE, PEDAL ASSIST SENSOR and HUB MOTOR, to the battery.
IMPORTANT: Be mindful of the arrows on each plug. Align arrows before inserting plugs together.
Poor installation may result in damaged pins and bad connectivity.
NOTE: This type of damage is not covered under warranty.
STEP 1: Connect the BATTERY to the THROTTLE cable using the
with the yellow male 3-pin plug
STEP 2: Connect the BATTERY cable to the MOTOR cable using the
STEP 3:
(OPTIONAL - Refer to installation instructions below)
using the
BATTERY/PAS CONNECTOR
STEP 4: Secure all your cables with zip ties.
NOTE: Make sure that the cables do not interfere with the steering or hinder the performance of the bike.
Damage due to the cables not being properly secured is not covered under warranty.
THROTTLE
CABLE
YOU HAVE FINISHED INSTALLING YOUR KIT AND ARE NOW READY TO HIT THE OPEN ROAD. ENJOY!
OPTIONAL
INSTALLING THE PEDAL ASSIST SENSOR (PAS) and MAGNET WHEEL:
The PAS and MAGNET WHEEL are optional. If you're interested in adding the optional PAS to your bike, spend a few more minutes to determine
if the magnet wheel will fit on your bike.
STEP 1: The MAGNET WHEEL is made up of two pieces. They will both have a "working surface" and ridge side.
A. Place each on either side of the spindle behind the DRIVE SIDE crank with working surface facing inward towards the seatpost.
B. Push together and use the aluminum ring to hold together. The aluminum ring should stretch and snap into place over/around
the two halves of the MAGNET WHEEL to ensure they will not separate.
STEP 2: On the DRIVE SIDE (chain) of your bike place the PAS at the bottom of the SEAT TUBE (right above the cranks and pedals).
A: Make sure the red LED is pointed up and the "target" logo is pointed down.
B: Align the target with the MAGNET WHEEL magnets.
C: Use the provided zip-ties to attach the PAS securely to the seat tube.
Connect the BATTERY to the PAS cable
with the yellow female 3 pin plug
(OPTIONAL)
BATTERY / MOTOR
PAS CABLE
BATTERY / THROTTLE
CONNECTOR
TARGET LOGO
BATTERY/ THROTTLE CONNECTOR
BATTERY / MOTOR
CONNECTOR.
CONNECTOR
BATTERY / PAS
CONNECTOR
ALUMINUM RING
MAGNET WHEEL
EXAMPLE IMAGE SHOWS
BATTERY/MOTOR CENNECTOR
BATTERY CABLES
Advertisement
Table of Contents
