Horizon Fitness HILLTOPPER Installation Manual page 2

WELCOME TO YOUR HILLTOPPER HORIZON ELECTRIC BIKE KIT
Congratulations on the purchase of your Hilltopper Horizon 36V electric bike kit. And welcome to the
Hilltopper community of electric bike enthusiasts.
With a small but powerful 350W hub motor and a battery with a range of 25 to 50 miles, the Horizon
will get you where you need to go and back. The install should take around an hour depending on
your mechanical skills and enthusiasm. You can also take your bike and kit to a local bike shop to
have them install your kit. Install fees will vary with different shops.
When you finish your install, double-check that all the bolts are tightened, the connections are secured,
the wheel rolls freely, and the battery is charged. Start off slowly at first to get used to the assist.
AND THEN HAVE FUN!
Assumption of Risk, Release of Liability, Indemnity, and Hold Harmless Agreement
By purchasing these Products, I understand and agree to the following:
Bicycling and related activities are hazardous and injuries are common and ordinary occurrences
during these activities. I agree to assume all risks of death or injury to any part of the user's body
while using the Products.
any modifications made to the Products.
Non-steel and/or non-rigid forks (aluminum, suspension, etc.) are weaker than rigid steel forks.
forks are acceptable for use. I agree to assume all risks if I choose installation on non-steel and/or
non-rigid forks despite
Installing the Products on my bicycle adds additional forces to the bicycle frame and may change
handling characteristics. Well-adjusted, well-functioning brakes are key to safely using the
Products and operating any bicycle. I understand and agree that I will have my bicycle's brakes
inspected by a bicycle repair shop after installation of the Products.
To the fullest extent allowed by law, I agree to forever release and hold harmless
its owners, agents, employees, and affiliates from any and all responsibility or legal liability for
any injuries, damages or death to any user of any equipment and the Products listed in this
form, whether resulting from negligence or any other cause. I further agree that I will defend and
indemnify them if any claim or action is pursued for any injuries, damages or death relating to
bicycling or any related activities involving the use of this equipment and the Products.
I accept the Products herein "as is" and with no warranties, express or implied, beyond those
stated in this agreement and in the manufacturer's written limited warranty, if any.
I understand how the Products work and have received instruction and satisfactory answers to
any questions regarding the use and function of the Products. If this is new equipment, I
acknowledge receipt of the manufacturer's written instructions. If at any time the Products do not
seem to be working properly, I will stop using it immediately and
If the Products are to be used by someone other than me, I certify that I am acting as agent of the
user and that I will provide this form and all pertinent warnings and information to the user.
This document is a legally binding contract which supersedes any other agreements by and
between the parties, and which constitutes the final and entire agreement regarding the services
and the Products. This agreement is intended to provide a comprehensive release of all legal
liability which is binding upon and for the benefit of all parties, their heirs, agents, and assigns, but
is not intended to assert any claims or defenses that are prohibited by law. If any part of this
agreement is held to be invalid or unenforceable, the remainder will be given full force and effect.
This agreement will be interpreted, construed, and governed by and under Washington State law.
Exclusive venue and jurisdiction over the parties and the subject matter to this agreement will be
in the Superior Court of Washington in King County.
is not responsible for modifications made by me to my bicycle such as fork filing or
recommends installation of the Products on rigid steel forks,
recommendation.
recommends tightening the axle nuts with a force of not less than 28 foot-pounds.
return it for inspection and possible repair or adjustment.
although non-steel and/or non-rigid
and