Table of Contents
Advertisement
SYMpTOM
the marker is chopping or trapping paint.
the Ego9 fires yet bolt doesn't move.
the Ego9 does not fire.
low velocity first shot.
high velocity first shot.
the trigger very "bouncy" .
76.
pOSSIBLE CAUSE
SOLUTION
the break beam sensor system is switched off.
switch on the break beam sensor system.
the bolt is dirty, causing the sensor system to
clean the bolt.
incorrectly detect a paintball.
the break beam sensor system is dirty causing
clean the break beam sensor system.
the incorrect detection of paintballs.
the dwell parameter is set too low.
increase the dwell parameter.
bolt pin is not located in rammer correctly.
lift bolt pin and line up with position of rammer
correctly (see maintenance section).
trigger is set up incorrectly.
set trigger up correctly.
(see Advanced set-up section)
solenoid is not plugged into the Ego9 pcb.
plug solenoid into port on the Ego9 pcb.
the break beam sensor system is enabled but
fill loader with paint.
there is no paint.
micro-switch is not being activated.
Adjust micro-switch activation screw
accordingly.
micro-switch is damaged.
replace circuit board.
solenoid pilot valve is damaged.
replace pilot valve.
fsd comp parameter is too low to overcome
increase fsd comp parameter.
stiction on solenoid and / or rammer o-rings.
fsd comp parameter set too high.
reduce fsd comp parameter.
inline regulator pressure is creeping.
strip and clean inline regulator. replace inline
regulator piston if necessary.
incorrect filter settings.
check that your trigger filter and debounce
settings suit your trigger set-up.
trigger pull too short and return strength too
refer to Advanced set-up section for
low.
guidelines of how to adjust your Ego9 trigger
accordingly.
SYMpTOM
pOSSIBLE CAUSE
the break beam sensor system does not
the break beam sensor system is dirty.
appear to be reading correctly.
break beam sensors are the wrong way around.
the break beam sensor system is not
there is a broken wire or contact, or a short
reading at all.
circuit on either of the breech sensor cables.
Either sensor is back to front.
two or more balls are being fed into the
if the Ego9 is being used with a force feed
breech.
loader, it is possible that the loader is forcing
balls past the ball detent.
Ego9 is inconsistent.
inline regulator is supercharging.
leaking rammer Assembly ( leak gets
front ram shaft seal deteriorated.
louder when bolt is removed ).
Eye turns itself off after firing.
Eye is dirty.
Eye is faulty.
Eye is out of place.
when the Ego9 powers up, no game timer
the trigger is permanently depressed.
/ shot counter / rof indicator is displayed
and the gun will not fire.
QUICK GUIDE
SOLUTION
CONTENTS
ORIENTATION
keep the break beam sensors clean to ensure
QUICK SET-UP
correct readings (see maintenance section).
USING YOUR EGO9
check that the red receiver is on the right-hand
MENU TREE
side of the breech.
ADVANCED SET-UP
MAINTENANCE
check the plug of the cables.
FAULT FINDING
FAULT FINDING
check for cuts or pinches in the sensor cables.
SERVICE CENTERS
PARTS LIST
check that the sensors face each other when
installed.
SPARES & ACCESSORIES
change the rubber finger detent.
strip and clean inline regulator.
(see maintenance section )
replace front rammer shaft seal.
clean the eyes.
replace the eyes.
re-install Eyes. check alignment.
turn the front stop set screw in the top of the
trigger counter-clockwise until the display
reads correctly. if there is sufficient trigger
adjustment then turn the return force set screw
counter clockwise also.
77.
Advertisement
Table of Contents
