Led Indicators; Basic Functions; Troubleshooting - Jam HX-EP925 Instruction Book

LED INDICATORS

EARBUDS IN CHARGING CASE
Solid red
LED off
PORTABLE CHARGING CASE
Flashing white
4 White LEDs on
EARBUDS IN USE
Flashing red and blue
alternatively
Slow flash blue
EARBUDS IN MONO USE
Flashing red and blue
alternatively
Slow flash blue

TROUBLESHOOTING

1. Remove the earbuds from the charging case.
2. Quickly tap the touch sensor on both earbuds 5 times. This
will disconnect them from your device. Place them back in the
charging case.
3. Forget the JAM TWS ANC earbuds on your Bluetooth
Please view the device instruction manual for instructions on
how to forget a device.
4. Turn off Bluetooth on your device.
5. Remove both earbuds from the charging case.
6. Earbuds will automatically go into pairing mode once they are
taken out of the case. The LEDs on the left earbud will flash
red and blue alternatively.
7. Turn on Bluetooth on your device.
8. Pair to "JAM TWS ANC".
9. Earbuds not disconnecting from your device? The TWS
ANC Earbuds may automatically connect to your device if
put in a charging case that has no battery left. For the best
experience, periodically charge the case to ensure it always
has battery life.
EN
Charging
Charging complete
Charging
Charging complete
Earbuds are in sync with each
other and in pairing mode
Earbuds are paired with
device
Earbud is in pairing mode and
searching for a device
Earbud is paired with device
device.
®

BASIC FUNCTIONS

MUSIC
Play/Pause
Forward track
Back track
CALLS
Pick up a call
Decline a call
End a call
Take a second incoming call
Decline a second incoming
call
Swap between 2 calls
OTHER
Activate voice assistant
Turn off earbuds
Clear all Bluetooth
connections
ANC on
ANC off
Press either touch sensor
button once.
If using both earbuds, tap the
touch sensor twice on the right
earbud. If using one earbud,
tap the touch sensor twice of
the earbud in use.
If using both earbuds, tap the
touch sensor twice on the left
earbud. Note that back track
does not function when using
only one earbud.
Tap either touch sensor once
Press and hold either touch
sensor for 2 seconds
Tap either touch sensor twice
Tap either touch sensor once
Press and hold either touch
sensor for 2 seconds
Press and hold either touch
sensor for 2 seconds
If using both earbuds, tap the
touch sensor on the left earbud
3 times. If using one earbud,
tap the touch sensor 3 times
on the earbud in use.
Press and hold touch sensor
for 4 seconds.
Remove earbuds from case.
Tap the touch sensor on either
earbud quickly 5 times. You
will hear the pairing tone and
the LEDs on the left earbud will
flash red and blue. The earbuds
are now ready to pair.
If using both earbuds, tap
the touch sensor on the right
earbud 3 times (you will hear a
single tone).
If using both earbuds, tap
the touch sensor on the right
earbud 3 times (you will hear
two tones).
NOTE: ANC does not work
when only using one earbud.
6