Jam HX-EP925 Instruction Book page 3

SET UP
CHARGING YOUR EARBUDS
To charge your earbuds, place them into the portable
case. The red LEDs on the earbuds show that they are
charging. If the red LEDs do not appear when placed
in the case, adjust the earbuds to make sure they are
in line with the charging contacts. When fully charged,
the LEDs will shut off. It will take approximately 2
hours to charge.
CONNECT BOTH EARBUDS
STEP 1 – TURNING ON THE EARBUDS
Your earbuds will automatically turn on when taken
out of the portable charging case. If you need to turn
them on manually, you can press and hold the touch
sensor for 4 seconds on both earbuds.
EN
4s
CHARGING YOUR PORTABLE CASE
Plug the small end of the USB cable into the USB-C
port located on the back of the case. The LEDs on
the case will flash white while charging. When the
portable case is fully charged, the four LED lights will
remain on. Once the USB cord is unplugged, the lights
will turn off.
STEP 2 – CONNECTING THE EARBUDS TO
EACH OTHER
When you take the earbuds out of their case, they will
automatically sync to each other. The LED lights on
the left earbud will flash blue and red alternatively.
You will also hear a series of tones. Your earbuds are
now in pairing mode and searching for a Bluetooth
device to connect to.
®
3