Surface Mounting - Sylvania ValueLED Installation Manual

SURFACE MOUNTING:

Disassemble the driver box cover by removing the 4 hex head screws keeping them for later. Figure 1
1.
Loosen and remove the 3/4 plug on the driver box cover. Figure 2
2.
Drill 4 holes on the ceiling at 90 degrees from each other on along the circumference of circle of 84mm (3.3") diameter. Figure 3
3.
Fix the driver box cover to the ceiling with the appropriate hardware (provided by others). Figure 4
4.
Hang the safety cord attached to the driver to the hook inside the luminaire. Figure 5
5.
Make all wiring connections in accordance with NEC and local codes; If the fixture is equipped with sensor, adjust the sensor
6.
settings. Take relevant waterproof measures after the wires are connected. Figure 6
Fasten and close the luminaire. Figure 7
7.
Replace the screws removed in step 1, the product is installed. Figure 8
8.
FIGURE 1
FIGURE 4
FIGURE 8
FIGURE 2
FIGURE 5
FIGURE 3
FIGURE 6 FIGURE 7
3989108