Advertisement
INSTRUCTION SHEET
Bottom Mount Flange Clips
Figure 9
Part Number Figure
MAC224
MAC258
MAC2912
MAC21318
Drop Wires, Rods and Flanges
Figure 10
Through Metal Stud
Figure 11
Pentair, CADDY, ERICO CADWELD, ERICO CRITEC, ERICO, ERIFLEX, and LENTON are owned by Pentair or its global affiliates. All other trademarks
are the property of their respective owners. Pentair reserves the right to change specifications without prior notice.
TECHNICAL SUPPORT:
www.erico.pentair.com
1. Using hammer,
tap clamp onto flange
1 or 2 runs MC/AC to 1/8" [3] through 1/4" [6] flange - bottom mount, rotates 360
1 or 2 runs MC/AC to 5/16" [8] through 1/2" [13] flange - bottom mount, rotates 360
9
1 or 2 runs MC/AC to 1/2" [13] through 3/4" [19] flange - bottom mount, rotates 360
1 or 2 runs MC/AC to 13/16" [21] through 1-1/8" [28] flange - bottom mount, rotates 360
1. Squeeze fastener
2. Connect top edge over wire
3. Rotate into place
4. Release
Part Number Figure
#12 through 1/4" [6] wire, plain or threaded rod and
MAC24Z34
1/8" [3] through 3/8" [10] flange for 1 or 2 runs of MC/AC
10
3/8" [10] plain or threaded rod and 3/8" [10] through
MAC26Z34
1. Screw clip to metal stud
at passage way
2. Press MC/AC cable into clip
CFS242_F
2.
Application
Squeeze fastener
Rotate
into place
Application
9/16" [14] flange for 1 or 2 runs of MC/AC
Part Number Figure
MAC2FB
11
1 or 2 runs of MC/AC through metal stud
4 OF 4
© 1997-2017 Pentair All Rights Reserved
Press MC/AC Cable into clip
5. Press MC/AC cable into clip
Application
Advertisement
