Advertisement
INSTRUCTION SHEET
Parallel to Stud and up to 1/8" Flange
(Metal and wood studs)
Figure 1
Tee Grid
Figure 3
Beam Clamp
Figure 4
Pentair, CADDY, ERICO CADWELD, ERICO CRITEC, ERICO, ERIFLEX, and LENTON are owned by Pentair or its global affiliates. All other trademarks
are the property of their respective owners. Pentair reserves the right to change specifications without prior notice.
TECHNICAL SUPPORT:
www.erico.pentair.com
Figure 2
1. Place inverted "T" tab
2. Push curved tabs back
Part Number Figure
MAC2ATA
3
1 or 2 runs of MC/AC to accoustical tee bar
1. Place on beam and
tighten screw securely.
(Approx. 20 in-lbs torque)
Part Number Figure
MAC2BC
4
1 or 2 runs of MC/AC to 1/8" [3] through 1/2" [13] flange
CFS242_F
Flange Application
MAC2 snaps in half making 2 fasteners
for single runs of cable!
Part Number Figure
MAC2
1
MAC2T
2
1. Snap clip onto metal stud or
screw clip to wood stud
2. Press MC/AC cable into clip
against acoustical tee bar
over on opposite side
of tee bar and push down
Aplication
Application
2 OF 4
© 1997-2017 Pentair All Rights Reserved
Application
Metal or wood stuf and 1/4" [6] flange
1 to 4 runs of MC/AC to metal stud
3. Press MC/AC cable into clip
4. Note: An independent support
is needed to meet code
2. Press MC/AC cable into clip
Advertisement
