Page 1
AX260 AX440 AX460 AX490 AX3000M AX4000M AX5000M POWER SERIES INSTALLATION / OWNER'S MANUAL Mobile Power Amplifiers...
Page 2
INSTALLATION Preparation Please read entire manual before installation. Due to the technical nature of amplifiers, it is highly recommended that your Axxera amplifier is installed by a professional installer or an authorized dealer. Before You Start i t a ( . l...
INSTALLATION Connection Descriptions NOTE: Be sure to follow specific instructions included with your amplifier installation kit (not included with this amplifier). The information below should be used as a general guideline only. Power Wire (+12V) 'LVFRQQHFW QHJDWLYH EDWWHU\ WHUPLQDO EHIRUH SURFHHGLQJ &RQVXOW D TXDOLILHG technician for instructions if you are unsure.
Page 4
INSTALLATION Audio Inputs and Controls High Level Inputs Hi-Pass Filter RCA Line Inputs Crossover Mode Pass Through Low-Pass Filter Gain Bass Boost...
Page 5
INSTALLATION Power and Speaker Connections Remote Turn On Speaker Connections Ground Connection Fuse(s) +12VDC Battery Connection...
Page 6
INSTALLATION Audio Inputs and Controls RCA Line Inputs Bass Boost Pass Through Low Pass Filter Gain Slave/Master Controls Phase Control Data Link Subsonic Filter Remote...
Page 7
INSTALLATION Power and Speaker Connections Remote Turn On Speaker Connections Ground Connection Fuse(s) +12VDC Battery Connection...
INSTALLATION Typical Wire Routing MAXIMUM GROUND FUSE No more than 36" (1 meter) 12V BATTERY 12V DC (Power) RCA CABLES SPEAKERS 2-8 ohms REM (Remote Turn On) Main Power Connections Connect+12V, GND and REM wires accordingly. A suitable fuse MUST be installed on the +12V lead within 18"...
INSTALLATION Amplifier Connections 2 Speakers (stereo) Subwoofer (mono) Speaker Connections Connect speaker wires observing polarity. The minimum impedance load for the AX260, AX440, AX460 and AX490 is 2 ohms stereo and 4 ohms bridged. Use of loads lower than these is not recommended and may cause amplifier damage.
INSTALLATION Connecting Two Amplifiers - Bridge Mode Master/Slave Mode The Dual mono amplifiers feature a Master/Slave mode, where two amplifiers can be connected together. When two mono amplifiers are connected together, the power from both amplifiers is combined.
Page 11
INSTALLATION Connecting Two Amplifiers - Bridge Mode Master/Slave Mode (cont.) *MASTER For master amplifier, set the switch to master. This will route the signal through Line-out to the slave amplifier. Set the phase to 0, all adjustments for gain and sound are done on this amplifier.