Grounding Instructions; Drawer Installation; Model And Serial Number Location - XO Appliance XOMD24S User And Installation Manual

GROUNDING INSTRUCTIONS

This appliance must be grounded. The microwave drawer must be plugged into a wall
receptacle that is properly installed and grounded in accordance with the National
Electrical Code along with local codes and ordinances. In the event of an electrical
short circuit, grounding reduces risk of electrical shock by providing an escape wire for
the electrical current.
WARNING : Improper use of the grounding plug can result in the risk of
electric shock. Do not use an extension cord. If the power supply cord is
WARNING
too short, have a qualified electrician or serviceman install an outlet near the
appliance.

DRAWER INSTALLATION

1. Place the drawer adjacent to the wall or cabinet opening. Plug the power supply
cord into the electrical outlet.
2. Carefully guide the drawer into the prepared opening. Avoid pinching the cord
between the oven and wall.
3. Slide the drawer all the way until the mounting flange is flush with the face of the
cabinet.
4. Open the drawer. Using the four holes on the drawer as a template, pre-drill the
cabinet using a 1/16" bit.
5. Secure the drawer with the four screws supplied.

MODEL AND SERIAL NUMBER LOCATION

To locate the model and serial number, open the microwave drawer fully. The label can
be found beyond the back wall of the microwave cavity, facing up from the flat surface.
Cleat
Mounting
10
Parts supplied
4 Screws