Yamaha DTX-PRO Firmware Update Manual page 3

2.
Make sure to turn th e power off, and then connect the USB flash drive to the
[USB TO DEVICE] terminal on the rear panel.
3.
Hold down the [START/STOP] button and press the Standby/On switch to turn
the power on.
After a few seconds, the following message will appear.
Installer
[MENU]： Install
[EXIT]： Delete
Press the button
Yamaha Corp.
4.
Press the [MENU] button.
The following messag e will appear.
Installer
[MENU]： Execute
[EXIT]： Cancel
Program ver.*.**
Yamaha Corp.
5. Press the [MENU] button again to start the update process.
The process may take a few minutes.
When the update process is complete, the following message will appear.
Installer
Completed.
Turn power off.
Program ver.*.**
Yamaha Corp.
6.
Turn the power off.
This completes the update process.
DT X - P RO F i r m w a r e U p d a t e G u i d e
3