Range Hood Care; Cleaning - KitchenAid KVWC956KSS0 Installation Instructions And Use And Care Manual

Cleaning

IMPORTANT: Clean the range hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating range hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
Liquid detergent soap and water or all purpose cleanser.
■
Wipe with damp soft cloth or nonabrasive sponge, then rinse
■
with clean water and wipe dry.
Metal Grease Filter
To Remove Metal Grease Filters:
1. Use two hands to remove the metal grease filters. Grasp
filter handles, push toward the rear of the range hood and
pull down on the front handle to remove.
2. Repeat for each grease filter.
3. Grease filters should be cleaned using warm water, dish
washing liquid, and a non abrasive brush. Dishwasher not
recommended.
To Reinstall Metal Grease Filters:
1. Grasp filter handles and place rear of filter into rear track.
2. Push down on the rear handle and set the front of the grease
filter into the front track to secure.
3. Repeat for each filter.
Replacing a Heat Lamp
This range hood uses two 175 W maximum heat lamps. Turn off
the heat lamps and allow them to cool.
To Replace:
1. Disconnect power.
2. Remove the heat lamp bulb from its socket.
3. Replace the heat lamp bulb with the same type bulb and
tighten it in its socket.
4. Repeat steps 2 and 3 with the other heat lamp bulb if
necessary.
5. Reconnect the power.

RANGE HOOD CARE

Turn off the range hood and allow the LED lamp to cool. To avoid
damage or decreasing the life of the new bulb, do not touch bulb
with bare fingers. Replace bulb, using tissue or wearing cotton
gloves to handle bulb.
If new lamps do not operate, make sure the bulbs are inserted
correctly before calling service.
1. Disconnect power.
2. Push up on the lens and turn it counterclockwise.
3. Remove the bulb and replace it with a 120 V, 6.5 W
4. Repeat steps 2-3 for the other bulb if needed.
5. Reconnect power.
Replacing a LED Lamp
maximum LED bulb with a GU10 base. Turn it clockwise to
lock it into place.
15