KV-SW252M50/M60K/M61/M81/N60
1-17. PICTURE TUBE REMOVAL (Except KV-SW252M60K)
Note:
•
Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom
right and left.
1) Remove the rear cover.
2) Unplug all interconnecting leads from the Deflection yoke, Neck assy, Degaussing Coil and CRT grounding strap.
Remove Chassis Assy.
3) Place the TV set with the CRT face down on a cushion jig.
8 Earth Coating Assy
1-18. PICTURE TUBE REMOVAL (KV-SW252M60K)
Note:
•
Please make sure the TV set is not in standing position before removing necessary CRT support located on bottom
right and left.
1) Remove the rear cover.
2) Unplug all interconnecting leads from the Deflection yoke, Neck assy, Degaussing Coil and CRT grounding strap.
Remove Chassis Assy.
3) Place the TV set with the CRT face down on a cushion jig.
qs Screw Tapping 7+ Crown Washer (4x)
RM-GA002
qs Screw Tapping 7+ Crown Washer (4x)
6 Degaussing Coil
5 Holder, DGC
Removal (2x)
7 Spring Tension(2x)
Removal
qa Loosen the Deflection Yoke
fixing screw and remove it
6 Degaussing Coil
5 Holder, DGC(2x) Removal
7 Spring Tension(2x) Removal
4 Anode Cap Removal
4 Anode Cap Removal
qa Loosen the Deflection Yoke
fixing screw and remove it
– 8 –
0 Loosen the Neck Assembly
fixing screw and remove
Neck Assy & VM board
9 C Board Removal
8 Earth Coating Assy
0 Loosen the Neck Assembly
fixing screw and remove Neck
Assy & VM Board
9 C Board Removal