Selphy Cp770; Head Voltage Adjustment; Required Equipment; Preparation Before Adjustment - Canon SELPHY CP770 Service Manual

• SELPHY CP770

1. Head Voltage Adjustment

• Perform this adjustment when the MAIN PCB ASS'Y or the PRINT UNIT is replaced.
• When replacing the MAIN PCB ASS'Y, setting up the "Date Format" and the "Language" is required
in accordance with the destination.
[Destination]
Japan ; Setting up of the following is required;
Destinations other than Japan
; Setting up is not required;

1.1 Required Equipment

1 SELPHY CP770 that is confirmed to operate normally. (Prepare a SELPHY CP770 in addition to the
SELPHY CP770 that is brought in for repair.)
2 SD Card in which the standard image (gry_0100.JPG in case of the file stored in Service Manual) is
copied, which is supplied with this Service Manual.
Copy it to the folder "***CANON" in the SD Card. (Select the DCF format.)
3 Digital camera which has Direct Print function.
4 Interface cable supplied with the digital camera.
5 Digital voltmeter

1.2 Preparation Before Adjustment

Print the standard image (2) using the SELPHY CP770 (1) that is confirmed to operate normally, via
the digital camera (3).
Note: Use only the copy that was printed first.
If it fails to print, wait for five minutes and print the standard image again.
"Date Format" yy/mm/dd
"Language" Japanese
"Date Format" dd/mm/yy
"Language" English
1
s