GE PKW7000 Owner's Manual & Installation Instructions page 14

INSTALLING CABINET SUPPORT
23
1
IMPORTANT: When installed below a single or double
oven, check to be sure that any oven supports above
the cutout do not obstruct the 23
the warming drawer cutout.
■ A 2" minimum clearance between oven and
warming drawer cutouts are required. Additional
clearance may be required if 2 x 4 blocks are used
to support runners or solid floor of the oven above.
■ T he warming drawer may be supported by either a
solid bottom, 2 x 4 or 2 x 2 runners.
INSTALLING ANTI-TIP BRACE
WARNING
ANTI-TIP PRECAUTIONS:
The anti-tip brace must be installed to prevent the
drawer from tipping forward when opened and loaded.
Failure to do so could result in personal injury.
14
Installation Instructions
2" x 4" or equivalent runners
/ "
2
22"
27"
/ " required depth of
1
2
2" x 4" or equivalent runners
23 / "
1
2
■ T he support must be level and rigidly mounted,
flush with the bottom edge of the cutout.
There is no way to level the drawer once it has
been installed. Be sure supports are level.
■ T he entire weight of the drawer is supported by
the runners or solid floor and must be capable of
supporting 150 lbs.
9"
2x4 or 2x2 runners
or solid bottom
25"
30"
Install 2x4 or 2x2 anti-tip
brace against rear
cabinet wall 9" from floor
to bottom of brace
1" = 2.5 cm; 1' = 0.3 m
49-2000658 Rev. 0