Table of Contents
Advertisement
7.7.10 Contrast Modification (XCAP Std. Only)
The image contrast can be modified from the "Contrast Modification" section under the "Modify"
tab in the XCAP imaging window. Where to find this control feature is shown in Figure 17. The
contrast modification may not be required for the application at hand.
Figure 17: Contrast Modification Location on Toolbar.
In the contrast modification box, that can be seen from Figure 18, select "Stretch Contrast,
Histogram Percentile Endpoints" and click "preview". The contrast modification will now be applied
over the live image feed. The contrast can be adjusted using the low and high end percentile point
controls. The default settings are usually adequate for most applications.
NOTE: This control feature is only applicable with XCAP Std.
Figure 18: Contrast Modification.
21
Advertisement
Table of Contents
