Table of Contents
Advertisement
7.7.7 Miscellaneous Section
The "Misc" tab highlights the bad pixels that the NUC is correcting for, seen in Figure 14.
Figure 14: Miscellaneous Tab.
7.7.8 Manufactures Data Information
The "Info" tab displays information about the camera such as the manufactures data:
FPGA & Micro Version: The current firmware version of the camera is displayed.
Serial #: States the serial number of the camera.
Build Date & Code: Gives the date that the camera was built.
ADC & DAC Calibration Values: These are calibration values that are used to set the TEC set point
and read back the sensor and PCB temperatures. They are not needed for the user as the XCAP GUI
has simple buttons to set and read back these temperatures, discussed in earlier sections.
CCD & PCB Temperature: The current sensor and PCB temperature of the device can be read by
clicking "Update Temp".
Selecting "Highlight"
from this dropdown box
will show the bad pixel
map that the camera is
correcting.
19
Advertisement
Table of Contents
