Table of Contents
Advertisement
Note:
If the particular nature of the local gas supply makes it difficult to ignite the burners with the knob
turned to the maximum setting, repeat the operation without a pan in position and with the knob
turned to the minimum setting.
- Burners with safety valves
Some models are equipped with safety valves which automatically shut off the gas delivery in the
event the burner should, for any reason, go out.
To relight the burner, turn the knob to position O and repeat the ignition procedure explained in the
following paragraphs.
™ Using the burners
Depending on the type of electric ignition fitted, proceed as follows:
)
For models fitted with ignition incorporated in the knobs, turn the gas tap knob to the maximum
delivery position, then press and hold down for about 4÷5 seconds. Release the knob and
adjust the flame by turning the knob to the desired intensity.
)
'Warning':
The ignition device must not be used for more than 15 seconds.
If after this length of time the burner does not light, or if it goes out again accidentally,
wait 1 minute before trying to ignite the burner again.
)
For models fitted with ignition switch, turn the gas tap knob to the maximum delivery position,
then press the ignition switch and the knob, holding down for about 4÷5 seconds. Then release
the knob and adjust the flame by turning the knob to the desired intensity.
The panstand grids are designed to make the appliance easy and safe to use. Always check the
panstand grids are properly positioned before using the appliance. Furthermore, always check the
protective rubber feet are all present and correctly positioned.
Special "WOK" support grid (Fig. 35 optional)
This is placed on top of the triple crown burner when using a "WOK" (concave bottom pan). In
order to prevent serious malfunction of the burner, never use a wok without this special grid
and never use the wok grid for flat bottomed pans
Choosing the right burner
The symbols stamped on the control panel (fig.36) next to the knobs indicate which knob
corresponds to which burner. To choose the most suitable burner, take into account the diameter of
the pan as well as the pan capacity (see table).
The diameter of the pan must be proportionate to the burner power in order to ensure high yield.
Burner
Auxiliary
Rapid
Triple crown
Fish kettle
Pan diameter
Minimum diameter
60 mm (with
reducer)
200 mm
240 mm
Maximum dimensions: 140X350 mm
Maximum diameter
140 mm
240 mm
260 mm
4
Advertisement
Table of Contents
