Advertisement
Available languages
Available languages
In test mode, press UP or DOWN to select Sound and Auto Mode.
Sound Mode: It shows AUDIO CONTROL in English and声控程序 in Chinese
Auto Mode: It shows AUTO RUN in English and自走程序 in Chinese
In the status of Language selection, press UP or DOWN to select Chinese or English.
English Menu: It shows ENGLISH or CHINESE
Chinese Menu: It shows 英文 or 中文
4. CONTROL BY UNIVERSAL DMW CONTROLLER
4.1 DMX 512 Connection
1.
If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin adapter-cable.
2.
At last unit, the DMX cable has to be terminated with a terminator. Solder a 120 ohm 1/4W resistor between pin 2(DMX-
) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the last unit.
3.
Connect the unit together in a `daisy chain` by XLR plug from the output of the unit to the input of the next unit. The
cable can not branched or split to a `Y` cable. DMX 512 is a very high-speed signal. Inadequate or damaged cables,
soldered joints or corroded connectors can easily distort the signal and shut down the system.
4.
The DMX output and input connectors are pass-through to maintain the DMX circuit, when one of the units' power is
disconnected.
5.
Each lighting unit needs to have an address set to receive the data sent by the controller. The address number is
between 0-511 (usually 0 & 1 are equal to 1).
6.
The end of the DMX 512 system should be terminated to reduce signal errors.
7.
3 pin XLR connectors are more popular than 5 pin XLR.
3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)
5 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+), Pin 4/Pin 5: Not used.
13
Advertisement
