Nicols WP 500 Z Manual page 13

 DMX IN/OUTPUTS MAIN INPUTS
Main Function
To select any of the given functions, press the MENU button up to when the required one is showing on the display. Select
the function by ENTER button and the display will blink. Use DOWN and UP button to change the mode. Once the required
mode has been selected, press the ENTER button to setup, to go back to the functions without any change press the MENU
button again. Hold and press the MENU button about one second or wait for one minute to exit the menu mode.
The main functions are showing below:
NO ENGLISH DISPLAY
DMX512 ADDRESS
1
ADJ RED LIGHT
2
ADJ GREEN LIGHT
3
ADJ BLUE LIGHT
4
ADJ WHITE LIGHT
5
ADJ AMBER LIGHT
6
ADJ UV LIGHT
7
8
SIDE PROGRAM
9
ADJUST SPEED
10
11
12
13 SELECT LANGUAGE
fuse
001
Adjust the luminance of Red by UP or DOWN, press ENTER to save.
255
Adjust the luminance of Green by UP or DOWN, press ENTER to save.
255
Adjust the luminance of Blue by UP or DOWN, press ENTER to save.
255
Adjust the luminance of White by UP or DOWN, press ENTER to save.
255
Adjust the luminance of Amber by UP or DOWN, press ENTER to save.
255
Adjust the luminance of UV by UP or DOWN, press ENTER to save.
255
SET FOCUS
Select built-in program by UP or DOWN, then press ENTER to save
01
16
TEST MODE
RESET ?
Adjust DMX512 address by UP or DOWN, then save the data by
Set focus by UP or DOWN, then press ENTER to save
Select the speed of built-in program by UP or DOWN, then press
Enter Sound and Auto mode by UP or DOWN
Press ENTER to reset
FUNCATION
ENTER
ENTER to save.
中文or English
12