Advertisement
For wiring, see Fig. 6
For control panel wiring, see Control Panel Manual.
Energizing & Trial Run
1.
Before use, check the power supply voltage, frequency and other data carefully and
make sure they are in line with the requirements, and check if the ground wire is in
good condition and the electrical wiring is correct.
2.
A special key is provided along with the shipment of the door opener. Turn the key
counterclockwise (to disengage the clutch), push the sliding door and let the door
opener to operate without load. If the door opener works properly, then turn the key
clockwise (to engage the clutch).
3.
Turn on the power, start the door opener, and observe the sliding operation of the
sliding door.
4.
Adjust the magnet's position until the door is able to open and close in positions to
your satisfaction.
Care and Maintenance
1.
Apply some antirust grease to the end of the worm gear spindle located inside the
hole of the special key.
2.
Check frequently if the electrical grounding is in good condition.
3.
Check frequently if all parts and components are in good condition.
4.
The device uses advanced lubricant that requires no replacement or replenishment.
Tel. 0030 210 9846222
Fax 0030 210 9822276
Agiou Dimitriou 263, TK. 17342, Athens, Greece
www.seco.gr
5
Advertisement
