Advertisement
SC - SDCB102
Control Panel for Sliding Gate Motors
Mount the Rack
The easiest way to install a rack is to place it on the gear teeth of the door opener first,
disengage the door opener, and then push the door slowly to move the tack bit by bit to
the desired position. In this way, you can make sure that the teeth of the rack are
perfectly engaged with the teeth of the gear. When doing so, don't forget to mark each
mounting point. (See Fig. 2.) Be noted not to lay the entire weight of the door onto the
gear.
Door Opener Release Device (Open the door manually)
The door opener is designed with a lockable release device which enables you to open
the door manually in case of blackout. For the release device and its operations, see
Fig.3 and Fig. 4.
Install the Limit Switch
Install the switch bracket onto the rack by reckoning the final travel position. (See Fig. 5).
For a spring switch, adjust until to an inclination that the spring comes into contact with
the switch flapper. For a magnetic switch, the magnet should point to the motor and be
located according to the position of the magnetic limit switch inside the housing.
4
R
Advertisement
