Advertisement
Table of Contents
Assembly Instructions
Tools Needed
Cordless Drill
6" #2 Square Drive Bit
Soft Hammer
STEP 1: (a) Lay all pieces on a smooth soft surface such as cardboard or carpet to help avoid scratching. We suggest
using a 6" #2 Square bit to fasten all screws (available at your local hardware store). Be careful to not over tighten any
of the fasteners.
PORT ROYAL TABLE
E.C. Woods, Inc. Outdoor Furniture
(a)
Advertisement
Table of Contents
Related Manuals for E.C. Woods PORT ROYAL
Summary of Contents for E.C. Woods PORT ROYAL
- Page 1 Assembly Instructions E.C. Woods, Inc. Outdoor Furniture PORT ROYAL TABLE Tools Needed Cordless Drill 6” #2 Square Drive Bit Soft Hammer STEP 1: (a) Lay all pieces on a smooth soft surface such as cardboard or carpet to help avoid scratching. We suggest using a 6”...
- Page 2 STEP 2: (b) Put the legs together with the notches in the feet facing each other. Some pressure may be required to get the feet fully seated. Be sure to place something under this joint to avoid the chance of breaking the feet. (c) Put the leg braces together with the notches in the braces facing each other.
- Page 3 STEP 3: NOTE (f) Dining height will not have leg braces so the umbrella holder will mount directly to the top of the feet. (g) Put the leg braces in the notches in the legs making sure to work the leg braces into the notches a little bit at a time all of the way around (h) until they are all flush.
- Page 4 STEP 4: (j) Place the table top upside down on a clean soft surface (k) Place the leg assembly upside down into the frame of the table and center the legs (i) Fasten the frame to the legs with the 1 ¼” round head stainless steel screws provided. ecwoutdoorfurniture.com...
Need help?
Do you have a question about the PORT ROYAL and is the answer not in the manual?
Questions and answers