VDH Products ALFA(NET) 31 BS User Manual

VDH doc. 080736
Software: 080610_ALFA(NET)31 BS
* Working.
The ALFA(NET) 31 BS is a one stage heater thermostat for panel mounting. The read out is on whole
degrees. The thermostat has two set points. One for switch on and one for switch off the relay.
The ALFANET 31 BS is equipped with a RS 485 network connection for read out and control on the
Alfanet.
* Installation.
On the upper side from the ALFA(NET) 31 BS is shown how the sensor, supply and relay should be
connected.
After power up a self test is started. If the self test is completed the measured temperature will be
shown on the display. If the relay is energized the led 'on' will be light up.
* Control.
The ALFA(NET) 31 BS thermostat can be controlled by four push buttons on the front:
SET - viewing / changing from the adjusted value .
UP - raise the adjusted value.
DOWN - lower the adjusted value.
* Viewing the set points.
Viewing set point relay-on:
By pushing the SET key and the UP key simultaneously, the adjusted relay-on set point will be visible.
Also the led beside the UP-key and the led 'set' starts flashing.
Viewing set point relay-off:
By pushing the SET key and the DOWN key simultaneously, the adjusted relay-off set point will be
visible. Also the upper right decimal point starts flashing.
A few seconds after releasing the keys, the set point disappears and measured temperature will be
visible again.
* Changing the set point.
Push the SET key and simultaneously the UP or DOWN key so the relay-on or relay-off set point will
be visible. Release the keys. Push the SET key again and now the set point can be adjusted with the
UP or DOWN key.
A few seconds after releasing the keys, the set point disappears and measured temperature will be
visible again.
User manual ALFA(NET) 31 BS
Heater thermostat
Version: v1.1
File: Do080736.wpd
1
Date: 22-02-2011
Range -50/+50  C (1)