Installation; Selecting Installation Accessories - Blaupunkt 5RZ34410 Operating Manual

8. Installation

8.1 Selecting installation accessories

2. Cut out the worktop using the dimensions indicated in the drawing. Leave a gap of at least
50mm around the cut-out for the purpose of installation and use.
Ensure the worktop is at least 30 mm thick. To avoid an electrical shock and major deformation
due to heat radiating from the hot hob, only use non-conductive, heat resistant work surface
materials (wood and similar fibrous or hygroscopic materials may only be used as worktop
materials if they are impregnated). As shown in the following:
Note: The safety distance between the sides of the hob and insides of the worktop
should be at least 3 mm.
L W
288mm 520mm
Always ensure that the ceramic hob is well ventilated, and that air inlets and outlets are not
blocked. Ensure the ceramic hob is in proper operation condition without faults. As shown in the
following:
Note: The safety distance specified by the hood manufacturer must be observed between the
appliance and an exhaust hood installed above it. Please observe the instructions of the hood
manufacturer.
E F H
268mm 500mm 65mm
D A B
61mm 292(+1/0)mm 524(+1-0)mm
41
X P R
Min.
50mm 5.5mm 7mm