Ninja Intelli-Sense CT680SSCCO Instructions Manual page 7

40 Upon completion of processing, ensure
that the blade assembly is removed
BEFORE emptying container's contents.
Remove the blade assembly by carefully
grasping the top of the shaft and lifting
it from the container. Failure to remove
the blade assembly before emptying the
container results in a risk of laceration.
41 Remove the Pro Extractor Blades
Assembly from the High-Speed Blender
Cup upon completion of blending. DO
NOT store ingredients before or after
blending them in the cup with the blade
assembly attached. Some foods may
contain active ingredients or release gases
that will expand if left in a sealed container,
resulting in excessive pressure buildup that
can pose a risk of injury. For ingredient
storage in the cup, use only Spout Lid to
cover.
42 If the appliance overheats, a thermal switch
will activate and temporarily disable the
motor. To reset, unplug the appliance
and allow it to cool for approximately 15
minutes before using again.
43 The maximum wattage rating for this
appliance is based on the configuration
of the Pro Extractor Blades Assembly
and High-Speed Blender Cup. Other
configurations may draw less power or
current.
SAVE THESE INSTRUCTIONS
44 DO NOT process dry ingredients without
adding liquid to the High-Speed Blender
Cup. The High-Speed Blender Cup is not
intended for dry blending.
45 Always exercise care when handling the
Slicing/Shredding Disc, as it is sharp. Use
the finger holes when placing or removing
disc. Failure to use the finger holes will
result in a risk of laceration.
®
46 DO NOT submerge the motor base or
touchscreen in water or other liquids. DO
NOT spray the motor base or touchscreen
with any liquid. Turn off and unplug the
motor base before cleaning.
47 DO NOT overfill.
48 DO NOT remove the container from
the motor base while the appliance is in
operation.
49 Keep hands, hair, clothing, as well as
utensils out of container while processing
to reduce the risk of severe injury to
persons or damage to the appliance. A
scraper may be used but only when the
appliance is not running.
50 Avoid contact with moving parts.
51 DO NOT attempt to operate the appliance
without the lid on.
n i n j a k i tc h e n . c o m 6