Using Your Total Crushing Blender Pitcher - Ninja Intelli-Sense CT680SSCCO Instructions Manual

USING YOUR TOTAL CRUSHING®
BLENDER PITCHER
IMPORTANT: Review all
warnings on pages 3–6
before proceeding.
TIP: If the Stacked Blade
Assembly is not fully
seated, you will not be
able to install and lock the
lid.
TIP: To learn more about
the unit's programs, refer
to page 10.
NOTE: Pre-set programs
have pauses and changes in
speed throughout the cycle.
NOTE: DO NOT add
ingredients before completing
installation of the Stacked
Blade Assembly.
NOTE: The pitcher can only
be installed in one orientation.
The handle must be
positioned on the front-right
corner of the motor base to
operate the appliance.
13 1-877-646-5288
1
Place the unplugged motor
base on a clean, dry, and
level surface such as a
countertop or table. Press
downward on the motor
base to adhere the suction
cups to the work surface.
Ensure the motor base is
connected to power.
2 Lower the Total Crushing
Blender pitcher onto the
motor base. The handle
should be aligned slightly
to the right and the pitcher
should be oriented so the
LOCK symbols are visible
on the motor base. Then
rotate the pitcher clockwise
until it clicks into place.