Advertisement
.Assembly of the lightformer
Position the speedring so that the smaller diameter which will be
attached to the flash unit faces the ground and insert the metal rods by
using the following boreholes:
Striplight: S1-S3-S2-S4; Softbox: 1-2-3-4; Octaform: 1-2-3-4-5-6-7-8.
For mounting the Grand Para, all 16 boreholes are to be used.
Flap up the release corner and insert the opposite end of the rod deep into the loop.
Work diagonally. If all rods are in place, push the rods under slight pressure back and
close the release corner with the velcro.
Fix the inner diffuser by pressing the buttons.
Fasten the outer diffuser with the velcros.
Textile honey combs are as accessory available and can be fixed with velcro.
.Mounting to a flash
To attach a lightformer to a flash unit, the clamps are put into the open position by pressing
the lever on top of the housing of the flash unit against the spring force until it hits the stop
and keep it there. Now place the speedring with mounted lightformer evenly and flush to
the unit (for accessories with Bowens S-type adapter, place the three flanges of the
accessory that they fit into the corresponding recesses). Do not tilt accessory during this
process. Then return the lever to its initial position moving with the spring force to lock the
accessory into place. To remove the accessory, hold it firmly (caution - it could be very
hot!), press the lever against the spring force to unlock it and remove the accessory.
For demounting hold the lightformer firmly to prevent the heavy metal ring from dropping
down and damaging glass dome and flash tube (danger!).
Contact
information.
PRIOLITE GmbH
Gattinger Str. 7
D-97076 Wuerzburg
PRIOLITE GmbH Würzburg/Germany - Page 2 - August 2014
Instruction manual PRIOLITE Lightformer PREMIUM
.
unit.
Tel.: +49 (0)931 20700000
Fax: +49 (0)3222 4307127
E-mail: info@priolite.com
Web:
http://www.priolite.com
Advertisement
