Merck EMD Serono easypod Manual

EASYPOD
®
CHANGE THE DOSE
Always check that the dose is correct at the top of the easypod main screen.
1
then press the
MENU button on
the main screen.
2
Menu
Remove cartridge
down and choose
Device settings
CLINICAL SETTINGS,
Clinical settings
then press OPEN.
Teach me
Data transfer
Open Exit
3
Enter PIN code 0000 by
using the arrow key to
select 0 and press OK.
Repeat until you see
0000, then press OK.
4
Clinical settings
Dose settings
then press CHANGE.
Injection settings
Regional settings
Dose log
Connection
Change Back
HOW TO...
Power on the
easypod device,
Use the arrow
key to move
Press OK to the
warning message.
Select DOSE
SETTINGS,
Choose INPUT IN MG,
5
then press OK.
Change the dose using
6
the arrow buttons and
press OK after each change.
Confirm frequency, then
7
press OK. Confirm dose,
then press OK.
Dose adjustment:
8
Press OK.
If dose adjustment was OFF, after
pressing OK you will see a screen
asking you to confirm daily dose.
If dose adjustment was ON, after
pressing OK you will see a dose
spread screen with <10% or <25%.
Ensure the correct value is highlighted
in white, then press OK. Once the
screen displays minimum and
maximum dose spread, press OK.
The dose has now been
updated and you are back
in the Clinical Settings menu.
If you do not need to make
any other changes, press
BACK again, then press EXIT
to return to the main screen.