Advertisement
Quick Links
Advertisement
Related Manuals for CityEV EVline 100
Summary of Contents for CityEV EVline 100
- Page 1 EVline 100 Smart Configuration Revision 3, July 2019 CityEV Limited...
-
Page 2: Operating Modes
Operating Modes Charging Authorisation The EVline 100 Smart can be configured at the time of installation to operate in one of three distinct charge authorisation modes: Always authorised, free to use. Always authorised, free to use but can be enabled or disabled using key fob. -
Page 3: Operating Mode Configuration
Operating Mode Configuration Factory configuration: Charging Authorisation: Always authorised, free to use Maximum Charging Current: Back Office Communications Disabled Configuration Programming: 1. Press Start/Stop switch 2. Swipe master Key fob Middle green LED flashes 3. Within 20 seconds press start/stop switch Top LED flashes to indicate charge authorisation mode Top LED flashes in groups to indicate currently programmed authorisation mode as follows: 1 flash = Always authorised, free to use... - Page 4 After 20 seconds middle LED indicates maximum charge current Middle LED flashes in groups to indicate Maximum Charging current: 1 flash = 16A 2 flashes = 32A 5. Press start/stop switch to change mode After 20 seconds bottom LED indicates communications mode Bottom LED flashes in groups to indicate communications mode: 1 flash = No Communications 2 flashes = Back office communications enabled...
- Page 5 Each EVline 100 Smart is supplied with 2 master key fobs. Master key fobs can be used for normal charging authorisation and also for ChargePoint programming. Additionally, master key fobs can add new user key fobs to the system. User key fobs can only be used to authorise charging and cannot be used for system programming.
- Page 6 Notes Page 6...
- Page 7 Notes Page 7...
- Page 8 If the charge point has been installed under the OLEV Workplace Charging Scheme, central monitoring is an OLEV mandatory requirement. The Cityline EVline 100 Smart charge point as supplied is not configured to use the back office communications. First follow the instructions on pages 3 & 4 of this manual to enable back office communications on the charge point.