Bolton Furniture ANNP2971 Assembly Instructions

40"coat hook w/shelf

Table of Contents

Download this manual

REPLACEMENT PARTS

Please do not contact the company purchased from as we can help you faster.

Order replacement parts and hardware at"boltonfurniture.com"

. Use of power tool to assemble

this product will invalidate any

claim and damage this product

making it unsafe!!!

. Please assemble on a clean soft

surface to avoid damage.

ASSEMBLY INSTRUCTIONS

40"COAT HOOK W/SHELF

50 minutes

www.boltonfurniture.com

Page1

Tool Included

(Not included)

(Included)

Coat Hook w/Shelf 2020/3/9

Table of Contents

Do you have a question about the ANNP2971 and is the answer not in the manual?

Page 1 ASSEMBLY INSTRUCTIONS 40"COAT HOOK W/SHELF REPLACEMENT PARTS Please do not contact the company purchased from as we can help you faster. Order replacement parts and hardware at"boltonfurniture.com" Tool Included (Not included) . Use of power tool to assemble this product will invalidate any claim and damage this product making it unsafe!!! .
Page 2 Part List- 40" Coat Hook W/Shelf Identifying the hardware Identify the hardware using the illustrations below. www.boltonfurniture.com Page2 Coat Hook w/Shelf 2020/3/9...
Page 3 Step1 Step2 M6X60mm Note: If possible, we recommend that you secure cleat (B) to stud in wall. Step 3: Position Cleat (B) on wall in desired location where shelf will be hung. Make sure cleat is level. Step 4: Using Cleat (B) as template, align holes in cleat to studs in wall. Drill 1/8" pilot holes 3/4" deep. Page3 Coat Hook w/Shelf 2020/3/9...
Page 4 Step 5: Attach French Cleat (B) to Studs in wall in at least 2 locations using wood screws (E ) Wallboard Stud Step 6: If hole locations do not align with stud in wall, install the EZ Anchor(F) in to drywall by tapping it in to the predrilled pilot holes up to the thread, and then screwing the EZ Anchor in to the drywall.

40"coat hook