Operating Mode; Sigma Mode (Presence Of Master Clock Sigma); Autonomous Mode (No Master Clock Sigma); 4-Buttons Extension Box - Bodet HARMONYS Installation And Operating Instructions Manual

III - Operating mode
The setting of the SIGMA and AUTONOMOUS modes is accomplished by means of the IP Buttons
Box Embedded Web Server (Cf. page 21).
Note: refer to the manual 607726 for further explanation of the different modes, .

3.1 SIGMA mode (presence of master clock SIGMA)

IP Buttons Box in SIGMA mode allows :
- manually Start/Stop melodies.
- Enable/disable relays.
- Enable/disable programming.
All actions taken from the IP Buttons box transit via the master clock SIGMA. The control
commands are stored in the master clock, there is no disruption in the event of power failure.

3.2 Autonomous mode (no master clock SIGMA)

IP Buttons Box in AUTONOMOUS mode allows :
- Manually Start/Stop melodies.
If no master clock SIGMA IP box buttons sends a command directly to the Harmonys.

3.3 4-buttons extension box

To increase the number of manual controls, it is possible to add a four-button extension box.

3.4 Factory settings

To configure the product to its factory settings, press buttons 1 and 4 on the power box buttons
(up to 5 minutes after power-up). To check the product returned to the factory configuration, the
two LEDs are illuminated briefly.
The default configuration is as follows :
- Name : BODET-MAC address
- IP configuration by DHCP
- Multicast synchronisation
- Sending address : 239.192.54.11
- Mode : independant
17