4-Buttons Extension Box - Bodet HARMONYS Installation And Operating Instructions Manual

5/ Connect the Ethernet network cable to the RJ45 connector.
Ethernet cable category: 4, 5 or 6.
The broadcast mode will have to be selected in the Network configuration page of the
embedded web server (see page 19), in Multicast mode the address of the product must be the
same than that of the server (by default 239.192.55.1). Record the MAC address (identification
label on the back of the product) of the product, it will be useful during its detection by the Sigma
software in order to rename it.
6/ Close the housing by tightening the 4 screws (A).

2.2 4-buttons extension Box

The 4-button extension box is mechanically identical to the IP buttons box so is its installation
(refer to page 16).
Note: anticipate the routing of the cable linking both boxes through the top or rear when mounting
the box to the wall.
Warning: the 4-button extension box should be installed within 10 cm of the IP buttons box. We
recommend installing the boxes very close to each other (distance less than 1 cm).
1/ Open IP buttons box.
2/ Connect the linking flat cable to the connector on the card IP buttons box (see illustration
below).
Example :
16
Connection on the circuit board of IP buttons box
Wire molding