How To Proceed - Electrolux EWM09312 Service Manual

1.3 How to proceed

1. Identify the type of control in question (page 2) and access the diagnostic cycle (see page 3).
2. Read the alarm stored (page 4) and consult the instructions regarding the "alarm codes", (page 15).
3. Delete the alarms stored (page 14).
4. If you are unable to access the diagnostic mode, consult the chapter entitled "The diagnostics system
cannot be accessed" (page 25).
5. Should the main electronic circuit board need to be replaced, make sure there are no burns. (See page 68).
6. After all intervention, check the appliance is operating correctly using the diagnostic cycle (page 7).
7. Delete any alarm that may have been stored during the diagnostics operations (page 14).
Technical Support - A.D.L. 5/70 599 74 23-12 Rev.00