Electrolux EWM09312 Service Manual page 28

E13
Maximum overall water fill time exceeded (sum of all water fills between one drain phase
Run the diagnostic cycle and fill all the trays with water(phases 2,3,4)
N
O
Is the drain pipe positioned
correctly and not causing the siphon
Is the washing machine's water Is the washing machine's water
circuit efficient (leaking)? circuit efficient (leaking)?
Is the pressure switch's water circuit
efficient (leaking/clogged)?
Replace the circuit board and repeat the diagnostic cycle to check for any further alarms.
Is one or are all the solenoid valves not
working?
Is the resistance measurement of the solenoid
valve approximately 3.5÷4.5 KΩ? (Measure it
directly on the solenoid valve without wiring)
-(see Fig.3)-
Reconnect the connector and measure
approximately 3.5÷4.5 KΩ on the solenoid valve
wiring connector (on the circuit board side)
– (see Fig. 4) –
Between J13-1 and J13-3 washing
Between J13-4 and J13-6 pre-wash
Is the solenoid valve wiring ok?
Replace the circuit board and repeat the
diagnostic cycle to check for any further
alarms.
Technical Support - A.D.L.
and the next to avoid exceeding the maximum volume)
Are all the trays filling with water?
YES
effect? (Fig.1)
YES
YES YES
(Fig. 2)
YES
YES
YES
YES
E13: Water leaks
!
Check that all the connectors are correctly inserted
Repair the drain circuit and repeat the
diagnostic cycle to check for any further
NO
Repair the water circuit and repeat the
diagnostic cycle to check for any further
NO
Repair the water circuit of the pressure switch
and repeat the diagnostic cycle to check for
NO
Check whether the tap is open, if the water
pressure is too low and make sure the tubes are
NO
connected and not kinked.
Replace the solenoid valve and repeat the
diagnostic cycle to check for any further
NO
Replace/repair the wiring and repeat the
diagnostic cycle to check for any further
NO
!
28/70
alarms.
alarms.
any further alarms.
alarms.
alarms.
If there are burns on the circuit board,
see page 68
E13
599 74 23-12 Rev.00