National Instruments PXI-1006 Installation Manual

INSTALLATION GUIDE
PXI -1006 R
™
1
4
1 Mounting Bracket
2 M4 x 8 Flathead Screw (Qty. 8)
™ ™
PXI and National Instruments
323091A-01
M
ACK OUNT
To mount the PXI-1006 in an instrument rack, follow the steps below.
3 Rubber Feet
4 Bottom Feet
Figure 1. PXI-1006 in Rack Mount Configuration
1. Remove the rubber feet and bottom feet (as required) from the
PXI-1006 chassis.
2. Install the mounting brackets onto each side of the chassis using the
M4 x 8 flathead screws supplied. Note that you can recess the chassis
in the cabinet rack at 1 in. increments up to 3 in. (For reverse mounting,
install the brackets using the holes at the back of the chassis.)
3. Install the chassis in the instrument rack using four screws (not
supplied).
are trademarks of National Instruments Corporation.
© Copyright 2001 National Instruments Corp. All rights reserved.
3
4
1
2
5 Holes for Reverse Mounting
5
April 2001