Test Functions - Panasonic KX-FC971CX-S Service Manual

KX-FC971CX-S / KX-FGA521CX-S
7.4.

TEST FUNCTIONS

The codes listed below can be used to perform simple checks for some of the unit's functions. When complaints are received
from customers, they provide an effective tool for identifying the locations and causes of malfunctions. To do this, you set the
Service mode (Refer to OPERATION FLOW (P.47).) first, then operate the below test items.
Test Mode Type of Mode
FACTORY SET Service Mode
FLASH MEMORY Service Mode
CHECK
MODEM TEST Service Mode
SCAN CHECK Service Mode
MOTOR TEST Service Mode
LED CHECK Service Mode
LCD CHECK Service Mode
KEY CHECK Service Mode
MEMORY CLEAR Service Mode
(except History data)
VOICE PROMPT Service Mode
TEST
SENSOR CHECK Service Mode
PRINT TEST Service Mode
PATTERN
Note:
The numbers in the boxes (XXX) indicate the keys to be input for the various test modes.
Code
Operation after code
input
"5" "5" "0" Refer to Memory Clear Specification(P.49).
SET
"5" "5" "1" Indicates the version and checks the sum of the FLASH MEMORY.
SET
"5" "5" "4" Telephone line circuit is connected automatically, output the following signals
on the circuit line.
SET
1) OFF 2) 9600bps 3) 7200bps 4) 4800bps 5) 2400bps 6) 300bps 7) 2100Hz
8) 1100Hz
"5" "5" "5" Turns on the LEDs of the CIS and operates the read systems.
Refer to CIS (Contact Image Sensor) SECTION (P.106).
SET
"5" "5" "6" Rotates the transmission and reception motor to check the operation of the
motor.
SET
12: FAX TX / Reading memory
52: Recording paper is fed
22: Copy
34: Cutter
44: Paper reverse
Press [STOP] button to quit.
"5" "5" "7" All LEDs above the operation panel board flash on and off, or are illuminated.
SET
"5" "5" "8" Checks the LCD indication.
Illuminates all the dots to check if they are normal.
SET
Refer to OPERATION PANEL SECTION (P.104).
"5" "6" "1" Checks the button operation.
Indicates the button code on the LCD while the button is pressed. Refer to
START (any key)
BUTTON CODE TABLE (P.51).
Refer to OPERATION PANEL SECTION (P.104).
"7" "1" "0" Refer to Memory Clear Specification (P.49).
START
"7" "8" "4" You can hear the voice prompt from speaker after pressing "SET" key.
SET
"8" "1" "5" If you enter this mode and operate sensor levers with your hands, the LCD
display of the related sensor (or switch) turns ON / OFF. Also, when copying a
SET
document, the related sensor will turn ON / OFF.
For each sensor's operation, refer to SENSORS AND SWITCHES (P.149).
Do Sn Co Jm Ct : LCD DISPLAY
Do: Document set sensor
:Paper inserted. Turns on when a document is inserted.
Sn: Read position sensor.
:At the read position, turns on when the front cover is opened and the sensor
lever is pressed directory.
Co: Cover open sensor
:Turns on and off when the front cover is opened and closed.
Jm: JAM sensor
:When JAM sensor is on "Jm" functions.
Ct: Cutter sensor
:When cutter sensor is on "Ct" functions.
"8" "5" "2" Prints out the test pattern.
Used mainly at the factory to test the print quality.
SET
You can select 1~4. (See PRINT TEST PATTERN (P.51))
50
Function