Timer; Restore The Parameters To The Factory Values - COSMOGAS FRYO-6PI Instructions For Installation, Use And Maintenance Manual

7 - USE

7.2.5 - Timer

The timer functions are not active in this type of appliance. If
the timer function is activated inadvertently, the symbol
appears on the display (section 7.1). To remove this feature,
proceed as follows:
1.- Press button (it doesn't matter if the machine is on or
off). The display will appear as in Figure 7-8.
2.- Press "SET" button and the display will start flashing;
Figure 7-8 - Timer function
4.- Press the button to change the value from "00 01" to
"00 00";
5.- Press "SET" button to confirm the change;
6.- Press the button to exit the menù;
7.- Now the icon must not be longer present in the display.
7.2.6.- Restore the parameters to the
factory values
WARNING !!! Once the factory values have been
restored, these values must be reviewed by recorrecting
them as indicated in the "Factory value" column in section
7.4 and 7.5.
With the appliance it is possible to reset all the parameters to
the factory values by pressing the "M" and
for more than 5 seconds, until you hear an audible "beep".
Then review all the parameters of sections 7.4 and 7.5,
aligning their values with what is reported in the "Factory
value" column.
Figure 7-9 - Display when the appliance is OFF
FRYO PI
buttons together
32
COSMOGAS