Heating / Cooling / Dhw Operation Mode - COSMOGAS FRYO-6PI Instructions For Installation, Use And Maintenance Manual

7 - USE
7.2.3 - Heating / cooling / DHW operation
mode
With the appliance on, press the "M" button.
Each time "M" is pressed, a different operating mode can be
selected, identified by a characteristic icon, which appears
on the display (Figure 7-1, the first 3 symbols of the table).
WARNING !!! To control the appliance automatically,
through the HS-GND and CS-GND terminals in Figure 5-10,
parameter "08" (section 7.5) must be set to "1" or "2"
and enabled both functions, via the "M" key. If both the
heating and cooling function symbols (
not present on the display, it means that Parameter "08"
(section 7.5) is set to 0, so modify it to the desired value.
WARNING !!! If only the
on the display, the related function works continuously
without being controlled by any room thermostat.
WARNING !!! If the symbol "
appear on the display (section 7.1), press and hold the M
button until it appears (Figure 7-5).
Figure 7-5 - Showing "Water Temp."

If the appliance works only for the production of DHW
(section 7.5, Parameter "08" = 0) the symbol
In this mode the symbol
Figure 7-6 - Display shows DHW mode
FRYO PI
and ) are
or icon appears
" does not
is present.
never appears.
30
COSMOGAS